Cellular Talk: Questions and answers

Saturday, June 19, 2010

Questions and answers

Hi
Lets start to discuss your frequent questions and try to get their answers.....

3 comments:

AnonymousJune 20, 2010 at 9:37 AM
What should be optimum value of T200?
ReplyDelete
Replies
AnonymousJune 22, 2010 at 11:01 PM
780 ms
ReplyDelete
Replies
jasonbobDecember 22, 2019 at 5:58 AM
golden goose
goyard bags
golden goose outlet
golden goose outlet
golden goose outlet
goyard tote
yeezy supply
supreme outlet
moncler
goyard handbags
xiaofang20191222
ReplyDelete
Replies

Add comment

Popular Posts

1. What are the three services offered by GSM? Explain each of them briefly.

GSM PLMN Services Bearer Services Thse services give the subscriber the capacity required to transmit app...
What are the general triggers for an iRAT handover?

Ec/Io of best cell below a certain threshold (usually around -16 to -18 dB) or RSCP of best cell below a certain threshold (usually around...
What is the typical/most common bitrate that a voice call uses?

They should say 12.2kbps but may be different if they start talking about AMR and the different rates then the know more. Prod them to see...
.Explain in brief what is FER.

.Q: Explain in brief what is FER. Ans: FER= Number of erased blocks\ total no of blocks *100 It is the right measure of voice ...
Q:What are the reason of TCH Drop due to bad quality Uplink

Ans: Probable reasons for poor Uplink Quality 1. Poor Frequency plan (TCH) 2. Interference in UL 3. Overshoot of neighboring cells. 4....
Timing advance in GSM

Hi Do you know about Timing advance in GSM?? How its work? Which channel its use? How it is calculated ? All the calculation...
Q:how to Plan MAIO and HSN

Ans: For telecom engineers, it is very help full to know about MAIO. Basically there is a set of frequencies where the channels are hop to...
What is an active set, monitor set and detected set?

What is an active set, monitor set and detected set? Active Set: the set of cells with which the UE is currently connected/communica...
In the Link Budget, what is a Shadow Fade Margin for and what factors does it depend on?

The shadow fade margin is dependent on the target percentage area coverage, the propagation model, and the standard deviation of the logno...
Question: Explain Ec/Io and RSCP; on what channel are they measured on?

Question: Explain Ec/Io and RSCP; on what channel are they measured on? Answer: Ec/Io = energy of carrier over all noise. RSCP = Receive ...

Cellular Talk

Saturday, June 19, 2010

Questions and answers

3 comments:

Popular Posts

Most Popular

.Explain in brief what is FER.

What does channelization codes do and function?

What are the general triggers for an iRAT handover?